![]() ![]() This enables power to the on board 5V regulator). Motor B lead out(Negative /For Motor A Output)ġ2V input from DC power source (12V jumper – remove this if using a supply voltage greater than 12V DC. Motor B lead out(Positive /For Motor B Output) Motor A lead out(Negative /For Motor A Output) Motor A lead out(Positive/For Motor A Output) Other extensions: current probe, controlling direction indicator, pull-up resister switch, logic part power supply.Max power: 25W (Temperature 75 Celsius).Enable signal level: Low -0.3V~1.5V, high: 2.3V~Vss.Controlling level: Low -0.3V~1.5V, high: 2.3V~Vss.Logic power output Vss: +5~+7V (internal supply +5V).Link to download the software: SPECIFICATIONS JOYSTICK MODULE Jumper wire (Male to female) – 40 pieces eachĪrduino IDE (Programmable platform for Arduino).Jumper wire (Male to male) – 40 pieces each. ![]() ![]() Two enable inputs are provided to enable or disable the device independently of the input signal HARDWARE REQUIRED L298N is a high voltage, high current dual full-bridge driver designed to accept standard TTL logic levels and drive inductive loads such as relays, solenoids, DC and stepper motors. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |